Scarlet W EVF/LCD Pogo won't work

[Ben Meserve]

Hey everyone, I just bought Wooden Camera's Pogo to Pogo connector and it doesn't seem to work on the left side pogos on my SW. I tested the cable on the top pogo adapter and it works fine. Thought it was the side pogo, it works with my 4.7 inch. Did a restore of the camera, problem is still there. Am I missing something? Can you not use the side pogo?

 

[Phil Holland]

The cable itself in the WC connector will need to be checked out. I've seen more than one person have issues with them.

 

[Daniel Stilling]

I would check on the monitor settings weather the HDMI or the side monitor output are turned on. A little known fact to many is that the side output and HDMI do not work at the same time...

 

[Ben Meserve]

Definitely the cable. Looks like I'll have to return. Thanks!

 

[David R]

I'm having a similar problem with a Wooden Camera Pogo, but its intermittent. Mainly when changing menu settings or powering up it will loose signal and I will have to unplug it and replug it in again to get picture. This is using the side pogo connector on a Scarlet-W.

Does Wooden Camera know about this problem? Just trying to figure out wether I should return the cable or if its a Red Firmware problem...

 

[Ben Meserve]

I'm having a similar problem with a Wooden Camera Pogo, but its intermittent. Mainly when changing menu settings or powering up it will loose signal and I will have to unplug it and replug it in again to get picture. This is using the side pogo connector on a Scarlet-W.

Does Wooden Camera know about this problem? Just trying to figure out wether I should return the cable or if its a Red Firmware problem...

I went to Wooden Camera in Burbank and they swapped the pogos out for me. Apparently something was wrong with the pins.