viewing Anamorphic in camera on Dragon is different than on Epic?:(

[Brad Hawkins]

Some people would probably like the record 6K full frame with a 2X anamorphic squeeze, crop later, but be able to desqueeze the viewfinder image independently (maybe that's already an option.)

I would also suggest support for 1.33x (Hawk lenses?) and 1.5x (Iscorama) squeeze factors. Honestly I don't see cropping in post being that big an issue, I think the viewfinder should be the top priority.

 

[Sidney L. Plaut]

the good thing about in camera cropping is, as your are recording less of the sensor, you should therefore should be able to use lower compression/ higher frame rates.

 

[Jason Diamond]

I would also suggest support for 1.33x (Hawk lenses?) and 1.5x (Iscorama) squeeze factors. Honestly I don't see cropping in post being that big an issue, I think the viewfinder should be the top priority.

There is currently 1.3x ana modes in the firmware and those should show up much better in the viewfinder than the 2x ana modes.

 

[Brad Hawkins]

There is currently 1.3x ana modes in the firmware and those should show up much better in the viewfinder than the 2x ana modes.

Good to hear!

Hopefully 1.5x will be included as well in an upcoming release.

 

[Brad Hawkins]

the good thing about in camera cropping is, as your are recording less of the sensor, you should therefore should be able to use lower compression/ higher frame rates.

I'm not sure this would actually be true... Reading through other threads, it seems like the FPS and compression are in direct relation to the vertical resolution, not the horizontal resolution.

http://www.reduser.net/forum/showth...-motion-framerates-max-resolution-compression

 

[John Marchant]

FPS is affected by vertical resolution only, compression by overall resolution.

Cropping for ana appropriately helps your compression quality.

 

[Björn Benckert]

Select 4K resolution with the aspect ratio 5:4... then enable 2x anamorphic mode. That's 6K ANA.

But christopher that only gives you a hight of 3072 pixels in hight not the full 3160... I know only 100 pixels but still, really want to max out on the sensor now when having it.

So is it not possible to get the full sensor hight and 2,40:1 Ana X2?

Would love to see the above on the full width monitor but record 6kFF on mag. Or have the option to record with lower compresison if the "pillar box" is not recorded.