I found this youTube video interesting about using the REDMOTE to change focus:
https://www.youtube.com/watch?v=vz1WI0Pew0Q
However, the video is 3.5 years old and I'm currently using the 6.0.31 firmware with the REDMOTE 9.3.11 firmware.
The video is using the Rack focus mode, but unlike the video, the new software doesn't allow a Rack with only 1 Rack Point (although the manual on page 132 states 1-4 Focus Points).
It kind of works with the REDMOTE, but you bounce between the two points after you press enter on the REDMOTE.
The 'Single' mode kind of works. You have to select a point using the LCD screen, and then you can move it around with the REDMOTE, but after you've done that once, the REDMOTE starts controlling the menus not the Focus Point - so ... I'm sure there's a better workflow I"m overlooking?
https://www.youtube.com/watch?v=vz1WI0Pew0Q
However, the video is 3.5 years old and I'm currently using the 6.0.31 firmware with the REDMOTE 9.3.11 firmware.
The video is using the Rack focus mode, but unlike the video, the new software doesn't allow a Rack with only 1 Rack Point (although the manual on page 132 states 1-4 Focus Points).
It kind of works with the REDMOTE, but you bounce between the two points after you press enter on the REDMOTE.
The 'Single' mode kind of works. You have to select a point using the LCD screen, and then you can move it around with the REDMOTE, but after you've done that once, the REDMOTE starts controlling the menus not the Focus Point - so ... I'm sure there's a better workflow I"m overlooking?