REDCINE 4K 16:9 In and Out points

[cinepost35]

I wanted to know if it's possible to set in and out points on mutliple clips of 4K 16:9 in Redcine ? Then output SD files for FCP offline. Then come back to redcine with Crimson to render out from 4k. I'm trying to come up with a quicker workflow without having the proxie files in 4K.

Does anyone have a better 4K 16:9 workflow at this point in time?
Does anyone know if 4K proxies are coming in build 16?

 

[Chris Gearhart]

There're some shortcuts that can eliminate steps, but this will get you going with rendering specific in/out points in REDCINE:

- Find your starting point along the timeline and note the frame number (e.g. 54,679); then do the same with your end point (e.g. 95,220).
- Hit the "Range" button, then select the frame number of the in point to the left of the scrubber--the calculator will pop up.
- Enter your "in" point (54,670).
- Do the same with your out point (to the right of the scrubber).

This will give you all clips between your in/out points on the range bar and when you hit "Go", only those clips will render. (Hit "Range" again and it will go back to the whole timeline.)

-Chris