Again, not reading RMDs right at import

[Gunleik Groven]

Hi

I have tried to contact DaVinci support about this, but no response so far...

Issue is that sometimes, resolve seems to get stuck on one RMD and applies that to the full project.
Last time trhat happened, I was low on time and just figured this was my fuckup.

This time, though, I have had time to check, and it is a resolve mess.

Here is the same clip in resolve and RCX

Resolve

RCX

So... I did a full fresh conform after making sure the RMDs were in the R3D folders, and still all clips get the wrong settings.

You'll have to rightclick on the image and choose "show image" to see the settings...

Wassup?

G

 

[Vico Martin]

... and if you choose "Decoding Clip using": Camara metadata ?

 

[Gunleik Groven]

That kinda worked. AND reset the clip metadata to the "right" settings...

Ouch


G

 

[Rob Ruffo]

You have to re-import your media - Resolve only remembers one settings per clip, per project - then it stay stucks on that - it doesn't matter what you do in Redcine - you can only change it in Resolve itself.

Only a fresh project will fix it, or you could copy the media to a new drive and replace it. There is no "reload from RMD" function like in Premiere.

 

[Gunleik Groven]

This time around I had some time to play with it, and batch setting the clips to another setting, seemed to make resolve read it right...

G