Washers

[Yuki Noguchi]

Where can I buy the washers on the back of Epic? I am missing one and I need them for my battery pack. I contacted Red but they don't sell them. Anyone recommends a good place to get one?

 

[Tony Mac]

Not cheap but this is probably what you're looking for! http://www.viewfactor.net/products/screws/screw-apu-kit.html

 

[Vance Colvig]

PM me. I might have something for you. Might also try McMasters Carr or Aircraft Spruce and Specialties.

 

[D Fuller]

You might try going to a good hardware store and looking in the fasteners isle in the stainless steel section. You'd be surprised how many times you can find exactly what you are looking for at a fraction of the cost of any camera-related seller. Some camera parts are special. But many are just standard nuts and bolts.

 

[ericyoung]

Plenty of M4 washers available. Think hardest part will be matching the exact 2mm thickness as most washers aren't made to tight tolerances - no idea if the thickness tolerance is critical - it may not be. I no longer have an Epic to check.

If you think the thickness is critical on examination, then measure your existing ones with vernier/digital callipers. Then take your callipers to a hardware store & find one which matches.