v2.0.8 Beta LCD goes blank

[Antony M]

I have had this happen 3 times since I installed v2.0.8 Beta, and it never happened with v2.0.5.

What happens is when I press the top button on the LCD (1:1 magnify), the screen goes totally blank.

I then power down the camera by holding in the side red button for 5 seconds.

Then when I turn it on again, I get the warning "Improper Shutdown".

 

[Trent Lillehaugen]

Can you double check the key mapping (although I'm not sure what mapping would cause this behavior). You may also want to send your log file to RED support.

 

[Antony M]

Hi Trent,

The key mapping is fine. It works about 75% of the time.

I will try to generate a log file.


What I am more worried about is whether this is causing any damage to the brain.

Thanks,
Antony

 

[Trent Lillehaugen]

Does this also happen if you toggle Magnify by some other method (mapped to a side handle key, or through the touch UI)?

What happens if you unplug and then replug the monitor when it is in this mode?

 

[Antony M]

Does this also happen if you toggle Magnify by some other method (mapped to a side handle key, or through the touch UI)?

What happens if you unplug and then replug the monitor when it is in this mode?

Red Support asked me to re-install the v2.0.8 firmware, so I did.
Now this exact problem hasn't happened again, but I am now getting different problems with the LCD.
Sometimes it has a "split screen" effect.

It looks as if the right side of the image is on the left side of the screen.

 

[Jake Bastian]

I've seen that before as well on an older build (the split screen). It was solved by a reboot, but it'd be nice to know what caused the problem initially. I haven't seen it so far on the latest release build.