Shaun Au
Well-known member
Guys,
I have an issue with my Red One with Mysterium sensor. After I upgraded the latest firmware(build 31), it fails to boot up. The firmware upgrade was successful. I performed it last weekend. Only want to turn on the camera to shoot something this weekend again. I never had this kind of problems before after major firmware upgrades. This is so strange.
The LCD display on the backside of camera displays just the standard menu info, but there's no input in red EVF or LCD. The normal booting up procedure will have previews in EVF and LCD through lens after you turn on the power button. In my case, they're all black. EVF has a small text "EVF not selected" at the lower left corner(see attached photos). A few minutes after I turn on the power switch, the fan starts to run. Anyone knows what's going on?
Thanks.
Shaun
Update: I powered off and powered back on. The LCD reads different this time and it stays there.
I have an issue with my Red One with Mysterium sensor. After I upgraded the latest firmware(build 31), it fails to boot up. The firmware upgrade was successful. I performed it last weekend. Only want to turn on the camera to shoot something this weekend again. I never had this kind of problems before after major firmware upgrades. This is so strange.
The LCD display on the backside of camera displays just the standard menu info, but there's no input in red EVF or LCD. The normal booting up procedure will have previews in EVF and LCD through lens after you turn on the power button. In my case, they're all black. EVF has a small text "EVF not selected" at the lower left corner(see attached photos). A few minutes after I turn on the power switch, the fan starts to run. Anyone knows what's going on?
Thanks.
Shaun
Update: I powered off and powered back on. The LCD reads different this time and it stays there.
