sync multiple cameras and audio?

[Stuart English]

Timecode Sync

Timecode Sync

Yes, give it a try, its been verified to work on Build 15 and 16... so something is up..

 

[Andrew M.]

Im not sure this will work. I have noticed that once a TC is locked (with the icon) on the red, it doesnt appear to accept any new TC signals. In one instance I had a synced the red and shot a couple of takes, before sound decided that they were going to change TC (dont ask me why). So I attempted to re-jam the red, but it would not accept the new TC. I had to go disable the Jam feature in the menus, then re-enable it for it to get the new correct TC.

But at the very least, you will have instant TC on new batteries.

No, you just have to press record button for couple of seconds.
Jam sync is performed at the beginning of each clip, that makes sense since we want to be sinced each and every time we start recording.
So don't expect to see corrected TC once camera will get offsinc, till you press the record button.

Lock is done constantly though.

 

[David Battistella]

A beer for anyone that can show me how they have successfully jam synced in B15.

B15 3.2.5
We just shot three cameras for a 2hr concert with no drift and the slate matches the tc on three sources.

We used denecke boxes 23.98 and a TC slate. Everything was locked tight. Every take. every camera.

http://www.denecke.com/Products/tcgenerators/tcgenerators.htm#SBT

We staggered the roll to keep the takes short and we did not miss a beat.

Net time I am in NYC, I will take you up on that beer.

David

 

[filip kovcin]

ok, my mistake...

simple - as stated eariler by Andrew- need to press rec button at least for a while.

everything looks good now.
sorry for messing...


filip

 

[filip kovcin]

Again - Not Good!!!

Again - Not Good!!!

PLEASE TAKE A NOTE - MY PREVIOUS MAIL STATING THAT EVERYTHING IS OK - WAS SENT BEFORE UPDATING TO NEW VERSION OF BUILD 16 !!!


I hope that this is again my mistake, but cannot say right now - we updated to newest build yesterday night b16 (3.2.1) and discovered that jam sinc is not working.

yes, we have strange situation with jamming BEFORE updating, and the problem was solved. that was MY mistake, not previous build version's.

today is something different. no posibility to jam at all. we tested different combinations with camera, but until now - nothig happened.

camera works in 25 frames mode, 2:1, RC 36. build 16 v 3.2.1


IMPORTANT - CAMERA IS WORKING WITH DEVA SOUND RECORDER