Welcome to our community

Be a part of something great, join today!

Log in
  • Hey all, just changed over the backend after 15 years I figured time to give it a bit of an update, its probably gonna be a bit weird for most of you and i am sure there is a few bugs to work out but it should kinda work the same as before... hopefully :)

Slow/fast motion on RED one

Select SENSOR then VARISPEED.

Enable VARISPEED via the check box. Use FRAMERATE to select the recording frame rate.

Playback frame rate wil be at the PROJECT FRAME RATE....


You may need to drop the PROJECT resolution if you are over cranking as it will not go faster than 30 fps at 4K resolution.
 
Question. Although you up the speed in varispeed would it still write in 24-60 frame space? by this i mean i tried upping the speed to 100fps but it was still written in 25 fps?
 
Last edited:
The frames of the clip are "written" at the varispeed rate that you have set.
The project setting for "time base" indicate the rate at which the clip is expected to play back.

If the time base is 24 fps, and you record at 48 fps, it plays back at half speed.

If you record at 12 fps it plays back twice as fast.

If the time base is 48 fps, and you record at 48fps it plays back at normal speed.
 
Yousuf Abbasi said:
Stuart, what GPIO device do you suggest for cases when I want to do ON EVENT ramp ?
Click to expand...

You can programme user buttons to be the trigger for the ramp, if you don't need to trigger it far from the camera.
 
You must log in or register to reply here.
Back
Top