Welcome to our community

Be a part of something great, join today!

Log in
  • Hey all, just changed over the backend after 15 years I figured time to give it a bit of an update, its probably gonna be a bit weird for most of you and i am sure there is a few bugs to work out but it should kinda work the same as before... hopefully :)

Rocket won't install

Gunleik Groven

Gunleik Groven

REDuser Sponsor
Joined
Dec 28, 2006
Messages
13,465
Reaction score
5
Points
38
Location
Norway
Website
quine.no
Hi

Sitting here with a brand new Mac 2x 2.26 quad osx 10.6.4 16 GB RAM ATI 4870.

Terminal window tells me that the firmware is upgraded, but RC-X tells me the card has wrong firmware/driver.

I have updated both several times.

Ideas?

G
 
RocketCine is EOL - you need to make the switch to REDCINE-X to get Rocket card support with the new Rocket drivers.

Gunleik - I think there might be a problem with the new website - I just upgraded to REDCINE-X v. 340 last week and also updated my Rocket drivers and I'm almost positive (would have to confirm this at my studio later today, to have absolute certainty) that the driver which I downloaded and installed (from the old website) was 1.3.3. - so to answer your question, the new website has included a mistake, I think, in the posted Rocket driver - it is a version behind and not up to speed with REDCINE-X 340.

You might want to send a direct email to RED, rather than posting here where it might be overlooked. I can confirm this afternoon, when I go into work, unless someone else is sitting in front of their recently updated Rocket card and can do it.
 
Thing is that the one on the support pages is 1.3.2, an 340 needs 1.3.3, which is somehow offline, but I had it hanging on a disk somewhere...
 
Likewise, I'm sure the Rocket system I set up last week was with 1.3.3 drivers. I was running RCX 340. I think the new website must be wrong. Not in the studio now, but I will be soon and I think I have the 1.3.3 installer there. PM me if you need it. I don't think posting a link publicly would be the done thing!
 
Thanks. I had it on an old computer, so the 1.3.3 did exist... -:) & Works here.

I can be pm'ed, too...

Now - setting up dreamcolor with aja hi5-3g...
 
You must log in or register to reply here.
Back
Top