Reconfigured Raven box to fit more stuff!

[Mark Gearhart]

The case included with the Raven is very nice, but the layout takes up a lot of space for the components so I had new foam designed for it. In this configuration, you can fit three Red Bricks, outrigger handle, 4.7-inch LCD, top handle. Camera with card installed, charger, two additional mini mags, sidewinder, 4AA batteries/charger, and mag reader. A piece of foam separates the two bricks while the rear brick appears to be mounted behind the camera, though it isn't. This is for FAA carry on flight restriction purposes. The outrigger goes in upside down and the LCD display perfectly slides into the recess on the bottom of the handle and holds firmly in place. The whole right side is available for cabling.

 

[Kabilen Mullaithilaga]

Interesting. How did you do it? DIY? Or some third party?

 

[jordan levy]

i did something similar for now, but using the existing foam and cut out larger areas with a box cutter.
like the compartment for the AC cord, made that one bigger rectangle cut out, so i keep the outrigger arm on and it land in that rectangle.
then altered the body cut out so i can keep a base plate and LW rod attachment on.
i only wish it was an inch taller and i could keep the monitor on too.
great case though, im so happy it came with the package!

 

[Mark Gearhart]

Interesting. How did you do it? DIY? Or some third party?

Had the foam remade from a local foam cutter company. Same material that comes in the RED case too.

 

[Joseph-Patrick Hung]

Check out 'Trekpak'!
You can reconfigure the layout with lots of ease!

Here's a fellow RedUser using one: http://www.reduser.net/forum/showthread.php?146222-Red-Raven-Case-with-Trekpak-for-Pelican-1510

 

[Reto Scherrer]

where can I get a Trekpak in Europe?