Dorian Weber
Well-known member
An early ver . of Firmware 4.0 showed it very well, and I loved it.
But then, upgrading to higher ver. I can not make it work any more.
I set the pre-recording to a target time. I am at 1:00:00:00 and set the prerecording to 10 sec.
In my understanding and experience before, the timecode numbers turn yellow and after 1:00:00:10 it will start at 1:00:00:00 again and will loop and if I press the record button at 1:00:00:05 the numbers will turn red and continue normal until I stop recording. But meaning to say, the 1st 5 sec (1:00:00:00-05 will be also recorded.
But... now, when I press the pre-record button, it will turn yellow starting at 1:00:00:00 and keep counting upward. With no difference.
What am I missing?
But then, upgrading to higher ver. I can not make it work any more.
I set the pre-recording to a target time. I am at 1:00:00:00 and set the prerecording to 10 sec.
In my understanding and experience before, the timecode numbers turn yellow and after 1:00:00:10 it will start at 1:00:00:00 again and will loop and if I press the record button at 1:00:00:05 the numbers will turn red and continue normal until I stop recording. But meaning to say, the 1st 5 sec (1:00:00:00-05 will be also recorded.
But... now, when I press the pre-record button, it will turn yellow starting at 1:00:00:00 and keep counting upward. With no difference.
What am I missing?