Nothing renders out from REDCINE-X 221

[jacknusa]

Nothing seems to be rendering out from REDCINE X

I select an Export preset - hit EXPORT - The clip shows up in the batch monitor window - for half an instant the status shows up as QUED, only to half an instant show up as FINISHED. The progress percentage though is sitting at 0% and never moves. Nothing is written to disk... What's going on?

I have tried the following:

A) Tried many different export presets
B) Disabling/Enabling Red Rocket
C) Tried exporting from BIN, PLAYER, AND TIMELINE
D) Disabled/Enabled audio
E) Tried exporting to many different disks
F) Made sure no Illegal characters are in the file paths
G) Rebooting computer

No changes - nothing is written to disk.

What's going on

Help

 

[joe hedge]

Make sure there are no funny characters in folder names or file path

!@#$%^&* etc are no-nos

 

[jacknusa]

Did that already (see above)

Any other suggestions

Jack

 

[Uli Plank]

Are you trying to write ProRes on a machine without it?

 

[Andrew Ravani]

check the disk

check the disk

I know this sounds stupid, but is it possible your disk is full? THis is what happens when RedcineX tries to write to a full disk.
Drew

 

[jacknusa]

Have tried ProRes and Uncompressed (and the machine does have ProRes CODEC available).

The disk(s) are either empty (newly formatted or only semi full (have tried 3 different disks.

Also: "good old" RocketCine-X has no problems rendering footage.

I'm at a loss...

Jack

 

[Jeff Kilgroe]

Have you updated your Rocket drivers and firmware recently?

 

[jacknusa]

Ok, I found the solution - the project file (containing about 400 clips in one bin) was the culprit... Open up a new project file and the same clips render ok - hovever, I'm not taking any chances and loading only one clip at a time...

Bottom line: seems the big project file tot corrupted somehow.

Jack