Welcome to our community

Be a part of something great, join today!

  • Hey all, just changed over the backend after 15 years I figured time to give it a bit of an update, its probably gonna be a bit weird for most of you and i am sure there is a few bugs to work out but it should kinda work the same as before... hopefully :)

My 5inch RED ARM Broke :( Can I fix?

Neil Dearman

Well-known member
Joined
Sep 2, 2012
Messages
1,127
Reaction score
0
Points
0
Location
Atlanta/Nashville
Website
neildearman.com
I was shooting a music video yesterday and my 5 inch RED Arm that was holding my Blade just stopped tightening up and the bolt with the thread broken :( Love these better than the Is-rial Arms. Can someone help?
 
I've fixed them in the past.

Usually it's the bolt that strips. I'd visit a local hardware store and bring the old one with you. Sometimes you have to kinda hammer the old one out of the scroud thingy that it's in but it's a simple long fully threaded bolt.

If they don't have them at the hardware store try mcmaster.com. But first determine which thread it is.

If it's the handle part that is stripped they sell those at Mcmaster too.

Good luck
 
Yeah the bolt stripped okay cool so it's a simple fix!!! Thx
 
Also be aware that sometimes when any of these Israeli type arms stop working they can be fixed by a company here in LA. My Acs have thrown away so many until now.
 
try mcmaster.com. But first determine which thread it is.

If it's the handle part that is stripped they sell those at Mcmaster too.

Good luck
Wow, that is a great source for gear! Thanks Troy
 
A bushie's remedy when all else fails. --- If ever you are well away from product support and run into a problem when the internal circlip in one or the other socket-end of an older long-sufferingly abused Noga Arm with thin circlip gives up and will no longer stay inside because the channel has become deformed from too much tightening. --- You can try cleaning the groove out as best you can with a fish hook or small flat jeweller's screwdriver. This is important as debris from the original failure forms a ramp the replacement circlip can ride up over and also fail. Form a replacement circlip from a piece of matching thickness flux-cored MIG welding wire. You will find these pieces in most auto-body repair shops or small metal fabrication workshops in some unexpected remote locations. In some instances but not always the hollow flux-cored wire will crush-deform into the mis-shapen groove and hang on until you can get the thing properly fixed or replaced. You may find that the "undamaged" section of the arm no longer holds firm. This will be because the groove in the damaged arm has become extended. You may be able to use both the MIG wire and the original circlip together with the original circlip positioned on the inside to restore the internal pushrod to its correct position. If the slotted socket-end of the arm itself has become spread open through combination of over-tightening and an accident, then the bets are off. You can try crushing the slotted socket-end in a machine vise back into correct clearance to the ball-end by initially crushing the slot narrower then turning the end 90 degrees and crushing the corners of the slot end itself as the socket shape will have become ovoid. This becomes a frantic remedy and is not assured of success. - No warranty of satisfactory performance of this desperate field repair is made, either express or implied. This lashup fix will not endure. The chronic need to overtighten a Noga Arm is a fair hint that a particular model is being used beyond its original designed performance. A heavier model, or the same general model but with shorter arms should be chosen to replace it. As always - my comments should be challenged against the opinions of more expert and competent people.
 
Last edited:
what is the size of the bolt for the 5 inch RED Arm? Anyone know I am ordering a new one at mcmaster.com and need to know the exact size/specs
 
Back
Top