LAGGING PROBLEMS!

[Luca Volpe]

Hi guys every time I go from the 100fps above in any format, everything is stucked...I can't press record, the screen is not responsive etc... happened today during a shoot...bummed!
Didi another atuo calibration but nothing...same problem....If I shot up to 75 fps in any format is ok...as I go highr than 100 all get stucked!
Note: I have nothing attached to it.(no extra monitors) The camera was in plug, and monitor is the 4.7 inch

 

[Luca Volpe]

I think I find a BUG!!
So, here is the problem explained in points:
1. From 100fps above in any format (from 8K donw to 2K) all the commands on the monitor are very lagging, in fact I had turn off the camera manually as nothing was responsive anymore. Also when you press the rec button you can't see the red dot on the screen. Below 75fps is all good. Above 100fps the camera don't even reach the exposure (is always yellow)

2. I have done both the auto blackshade and the manual at 5k 100fps. Nothing same problem.

3. ALL THIS was happening using Prores ONLY....then I thought to change to R3D ONLY and....it worked fine, no lagging on the screen...nothing. Any fps worked at any format.

4. The I switched to Prored PLUS R3d...and all was stucked again! I had to force turn off the camera!

So...from what I see there is a bug in the firmware where above some fps, using ONLY prores, the screen start to lag very bad.....

 

[darren scott]

Contact support and let them know.

 

[Luca Volpe]

I did