Image comes into Red Cine X flipped upside down.

[Gene Sung]

On my Scarlet-W, I have my 4.7” rigged upside down because I shoot in an ENG type rig. Obviously, I have the “Image Flip” checked.

This did not happen when I first got my Scarlet-W, but on the next firmware upgrade and ever since, the image shows up in Red Cine X upside down. The Flip Horizontal and Flip Vertical are both checked. To un-flip it under FRAMING CONTROL I usually just click the “D” (Default?) button.

However, Clicking “D” gets really tedious when there are lots of shots and I cannot seem to batch select and flip them all at the same time.

I notice when bringing it in Premiere, it comes in the correct upright orientation, not flipped. Only in Red Cine X does it flip the image which it did not do before.

Any way I can set a default so the image does not come in flipped in Red Cine X? Or do a batch select or have some Pre-Set so the image is set to the correct, upright orientation?

 

[Bob Gundu]

Just create a preset with the correct settings then apply to all clips in the Bin in one go.

 

[Gene Sung]

Hi Bob,

I've been struggling with Presets. I created a Preset for image flip, however it only works with "Clip in Viewer." None of the other options like "Bin (Selected Clips)" works and I get this error: "No Clips to apply framing to. no clips were selected and/or available."

Why does it only work with "Clip in Viewer" and none of the other options? What am I doing wrong?

 

[Bob Gundu]

Did you drag the clips from the top to the bottom project area?

 

[Gene Sung]

Thanks Bob, Project area it was.

One weird thing is that the images in the viewer now are the correct up-right orientation, however in the project thumbnails, the image is still upside down.

Whatever, not a big deal as long as the image is upright in the viewer it's all good.