Welcome to our community

Be a part of something great, join today!

  • Hey all, just changed over the backend after 15 years I figured time to give it a bit of an update, its probably gonna be a bit weird for most of you and i am sure there is a few bugs to work out but it should kinda work the same as before... hopefully :)

HELP! RED Drive problems

jake southard

Well-known member
Joined
Apr 29, 2014
Messages
705
Reaction score
9
Points
18
Location
Beverly Hills, CA
Website
www.jakesouthard.net
So i recently bought a RED One MX off ebay, and shot a few test shots, and plugged the 320gb Red Drive into my late 2012 iMac using a Firewire 800 cable to thunderbolt adapter of my iMac. When Plugged in, the Red Drive makes a "skipping" noise, like its having difficulties reading the drive, then the noise eventually goes away. BUT nothing pops up on my computer letting me know a drive is attached... I can't get my footage off! I have 2 of these drives, my OTHER drive, is recognized by my computer for a few seconds, then it ejects itself, and my computer says that the disk was ejected improperly. why would this be happening.. I'm VERY new to the RED world, and have NO idea what's going on.
 
first, try powering your drive off an AC adapter, and no, it doesnt have to be made by red if the polarity and voltage are right.
second, you may need to also use the usb socket on the drive.
The firewire sockets are buggy on these drives, especially at their current age.
 
Do your drives playback when plugged into the R1? If so, then the drives are okay and you most likely have a bad FW port.

I'd follow Christopher's suggestion and instead use the miniUSB port while the drive is powered by an AC adapter. Your transfer speed is half of FW but at least it may still work. :/
 
With the old Red Drives, you can only have ONE of them connected to the same computer at a time. If you connect a second one, it will cause the one of them to disconnect/eject itself as you've found!

For the other one, follow Christopher's and Brent's advice, although make sure that the AC adapter is centre pin positive. 12V dc, 1.5A.

Your power supply should also be a voltage regulated one to ensure a stable output voltage.
 
Ok, so yeah, here's the thing. The Thunderbolt port on any computer does not give out enough power to run the red-drives. If you first connect a powered thunderbolt Storage array and then the T-bolt to FW800 adapter, it will have enough power to run both drives spinning in there... Go figure... But that is the best solution I've found with using the RED Drives.
 
thanks for all the replies.. the problem was not only that there was not enough power going to the drive, but also, the Firewire 800 cord i was using was bunk. Don't buy from Belkin :/ I got a new cord and powered the drive through the wall outlet, and PRESTO. Got my footage on my computer
 
Back
Top