Jason Comparetto
Well-known member
- Joined
- Jun 2, 2008
- Messages
- 1,979
- Reaction score
- 0
- Points
- 36
- Age
- 43
- Location
- Anywhere planes fly
- Website
- www.cinemaoxide.com
Tried to uprade firmware to see if it was the camera, but no such luck. Still says DC 0% on the LCD. How can I really find out if it's the plate or the batteries? I looked inside the plate, and there was alot of glue and some dodgy soldering, don't know if it's wired correctly, but if someone could take a picture of their plate I could maybe compare? I'm sure I've seen a picture of the inside of a pro-x plate in here before, just can't remember where...Here's what I found when I opened mine:
I don't like where that magnet is sitting.
Try a little experiment. Pop the magnet off, center it and move it a bit closer to the release spring. Hold it there with your finger, and then start the camera. Don't start the camera until you firmly have your finger pressed down over the magnet. Let the camera boot up and see if you get a percentage reading. If not, its most likely "dodgy soldering" as you've already indicated. If that's the case, try this--
1) Put the battery plate inside a cardboard box.
2) ship it back to where you got it
3) Buy this one that works. http://www.cinemaoxide.com/oxide-battery-plate.php