Epic Pelican Case

[Peter Cote]

My Epic pelican case is slowly filling up with all my backordered accessories. However there are a few precut slots that I don't understand what they're cut for. There is a removable section right behind the Epic which I assumed was to fit the Redmote while still attached to the Epic body but the picture shows the Redmote in the pelican case to the right. So what is supposed to fill the section directly behind the Epic body? Also what goes in the lower right corner of the case. I couldn't figure out what is was in the picture.

 

[JamesLankford]

possibly the module adaptor can be left on the epic and still fit?

 

[Peter Cote]

It would have to be a pretty small module. Only like an inch thick so I doubt it.

 

[Christian Munoz D]

It is just an adaptor...no need to be bigger.

 

[Jason Diamond]

The lower right of the picture is for the side plate that comes with the cam in the event you remove your side SSD module and the other plate is for when you remove your sidehandle.

Also I'd imagine the rear adaptor module will be essentially the size of the REDmote in thickness to accomodate for the weight it will bear instead of the weight bearing on the epic body directly.