Dual Link Output on RED

[Vigen Vartanov]

Goog gay. Today we test dual link output on camera. With 2 cables and 1 HDLink and Cinema Display . I was waiting fot 1080p signal but we get same 720p signal but with colors like it was 4:2:2 signal . With 1 cable colors are fine , but with 2 cables is not corect. I read that Red have dual link support , but i did't found in settings . In Monitor menu there is only 720p. Did i need to wait for 16 buitd ? . Problem that we have is that picture is not on full screen with 720p . On Cinema Display 23' . May be it was HDlink problem ?
Thanks/

 

[Jarred Land]

Goog Gay?

 

[jbeale]

As far as I know, if you were expecting 1080p out of the Red you may be waiting for quite a while... it has been discussed in the past, you can search these forums for more about that.

HD Preview always is 720p (with lookaround), but the dual link output could be 1080p - but only when recording 1080 RGB.

From other postings, recording 1080 RGB is mutually exclusive with recording Redcode Raw (what all cameras currently do) and it would require a yet-to-be developed special firmware load.

 

[Vigen Vartanov]

Ops sorry God day . Ok i will check , just i was waiting for miniBNC to BNC converter now i get it and test it first time I sow it on Chart on forum . Ok will wait for 17-20 Builds.

 

[Tony Lorentzen]

God day?

http://www.reduser.net/forum/showpost.php?p=178131&postcount=161

 

[Adam Levins]

I think he means Good'ay Mate

like from down under.