Does Anyone Know if you can color calibrate the RED 7" touchscreen?

[Anton Esteban]

I noticed mine drifts green quite a bit compared to a properly calibrated monitor connected to the SDI port.

 

[Bob Gundu]

No adjustment control

 

[Jake Wilganowski]

No. mines a bit on the warm side.

 

[Steve Sherrick]

Unless you have an ability to add a calibration LUT, then no. RED would have to build into their firmware a way to load the display LUT into the path where there are already transforms going on. And you would of course need a way to get pattern generators to the display. I think the only way to realistically get these calibrated would be some kind of factory calibration and that's assuming the display can even hit the specs to begin with. I don't know enough about the design of the 7" to know what it's capable of producing for color and gamma.

 

[Manfred Baulig]

mine is always low light compared to the final picture. We did it side by side with the 5' and the 5' is still the best reference. Hopefully they will release a 5' somewhen again (the 7' just is too big for gimbal work und the smaller one is just....too small)

 

[Anton Esteban]

Even some very basic controls would be nice