correct LEMO cap?

[Ben Sliker]

Had a renter break a pin in our monitor cable. Would like to avoid that happening again. The connectors all have the LEMO '1B' designation on them.

Would this fit my needs?

http://www.mouser.com/ProductDetail...=iq0abfFbkOvHL5QJCRe3RSsWoQfCcqg19puRSC9rPD4=

 

[Justin R Goff]

This peaked my interest as well. After checking out the data sheet, it seems like that would LEMO 1B cable set. Ill probably order some for in-house equipment. Good find!

 

[Trevor Meeks]

Those are great. Please post back if they end up being the correct ones (I don't see why they wouldn't be) - I'd love to get some as well for my AC Adapter etc.

 

[Ben Sliker]

put in my order. will let you know how it goes. unfortunately, they were backordered, might be a while.

 

[Ben Sliker]

Ok, so 4 were on backorder, and they ended up sending me one.

Short Story - It works. Picture:

I was disappointed that it was a plastic cap, not the same metal that the LEMO plug end is made out of. The cap works perfectly for the LCD ANGLE and STRAIGHT ends. It in the end, it comes down to whether or not you want to pay $11 for a tiny plastic cap. The piece of mind for no bent pins in the future? That might be worth a little more to you.

THIS CAP DOES NOT WORK FOR YOUR POWER CABLE. That cable has 2 tabs (vs. 1 on the LCD cable) and will not fit.

 

[Trevor Meeks]

Thanks for following up, Ben!

 

[Les Dittert]

I'm going to try to find some type of soft plastic or rubber caps to work on them. Just a friction fit would be fine.

 

[joyce go]

This is the cap for plug.