I just got a RED scarlet and am planning to use it with our Dynamic Perception stage zero dolly. I understand that a four pin lemo cord is needed to connect the scarlet to the mx2. Does anyone know any suppliers of the correct cord for this? I haven't been able to find any online so far.
RED sells this cord which takes care of the Scarlet 4pin lemo end: http://www.red.com/store/products/4-pin-00-lemo-to-flying-lead. Does anyone know how to connect the lead end of this cord correctly to the MX2 controller? When I spoke with Dynamic Perception they clearly explained that two of the 4 pins correspond to power, and the other two to the trigger for the camera, so if they were accidentally connected improperly, it could send power the wrong way with dangerous results for the gear.
Any pointers on how to smoothly, properly connect the Scarlet to the MX2 for use with the stage zero dolly would be greatly appreciated!
Thanks!!
RED sells this cord which takes care of the Scarlet 4pin lemo end: http://www.red.com/store/products/4-pin-00-lemo-to-flying-lead. Does anyone know how to connect the lead end of this cord correctly to the MX2 controller? When I spoke with Dynamic Perception they clearly explained that two of the 4 pins correspond to power, and the other two to the trigger for the camera, so if they were accidentally connected improperly, it could send power the wrong way with dangerous results for the gear.
Any pointers on how to smoothly, properly connect the Scarlet to the MX2 for use with the stage zero dolly would be greatly appreciated!
Thanks!!