Cant use dual monitors with HDMI port and Lemo Adaptor A via LCD2 port

[Azzie Scott]

I have a Weapon with a JetBack Expander attached, and I have my 4.7 touch attached via Lemo Adapter A on the side and Lemo Adaptor B connected to the RED Touch.I have s secondary monitor attached via HDMI from the JetPack. The 4.7 just goes blank and the monitor via HDMI shows all the controls. This also happens in reverse if i plug my RED Touch in after the HDMI monitor is attached. So it seems that you can't use two monitors with one connected via the lemo adaptor A on lcd 2 port and a monitor via HDMI. This seem strange and I may be doing something wrong, but only one ,monitor works at a time. Can someone advise me.

 

[Azzie Scott]

Figured it out. you can not use both at the same time

 

[Matthew Quinn]

move the "lemo A" adapter to the top of the camera

 

[Joachim Hoge]

I just ran into the same problem with my Raven. Thanks for figuring it out.
Shame we can´t run all 3 at the same time, but moving the Lemo A to the top of the camera at least let the LCD that I have on the far side of the camera go black (and not the viewfinder) when I attach a Paralinx or HDMI for a director monitor
Wish I knew this before I ordered my Wooden Camera pogo cables as I might have swapped the lengths.
I have on short Pogo to Lemo to use my old Red viewfinder and a Pogo to Pogo to move the LCD off camera

EDIT Weird that changing the priority around dosen´t work, but you actually have to move the cables