Welcome to our community

Be a part of something great, join today!

Log in
  • Hey all, just changed over the backend after 15 years I figured time to give it a bit of an update, its probably gonna be a bit weird for most of you and i am sure there is a few bugs to work out but it should kinda work the same as before... hopefully :)

BNC out doesn't function!!

are you using the HDMI out at the same time?
 
no...only sdi...I don't know what happen....
I changed all the configuration about Monitor and nothing happen.
 
Have you tried a reboot of the system?
 
Awwwww crap! My HDSDI just stopped working this morning too. HDMI is ok, Panasonic monitors show "unsupported signal" when connected to HDSDI. Have tried changing from 1080p to 720p, from auto/23.98/29.97 and nothing works. Reinstalled 3.0.7 without success.

Everything was fine the other day. Put the camera in the box, pull it out and now it's not working.

Alexandre did you find a fix?
 
Log file sent in but crisis averted on my end.

I have Panasonic BT-LH80WP and BT-LH910G as onboard/portable monitors and BT-LH2550P as client monitor. This morning I was prep'ing with the older LH80WP that was on the shelf and kept getting the 'unsupported signal' error. Plugged the video into the Blackmagic board of my brand new on-set computer and just saw black. Tried different cables, no luck.

Unpacked the other two monitors and I have picture. Went into the BM card settings and checked the "use 1080p instead of 1080psf" option and I am getting picture to the computer too. Looks like I was bitten by the p/psf bug.
 
No, I instaled the 3.2.13 firmware and nothing works. I'm with the same problem in two scarlets.
 
Paul J Went into the BM card settings and checked the "use 1080p instead of 1080psf" option and I am getting picture to the computer too. Looks like I was bitten by the p/psf bug.[/QUOTE said:
Didn't the new build say something about only 1080p being supported? I recall seeing this on that new build no Psf any longer....
Click to expand...
 
Didn't the new build say something about only 1080p being supported? I recall seeing this on that new build no Psf any longer....
Click to expand...

We have never offered PsF output on any of our cameras, our HD-SDI outputs are true Progressive only. So please set your monitoring accordingly. If the monitor says "unsupported format" it's a good bet this selection is what the issue is. Most HD-SDI chip sets do support true Progressive mode as well as the interlace based PsF mode, but some don't which is unfortunate.

If you are seeing issues with 720p out, it may be because your monitor is only capable of accepting 720p / 50.00 or 720p / 59.94 fps. In that case verify that the HD-SDI out from the camera says one of those - it's possible it may be set to 720p / 23.98 and again there are some HD-SDI chips sets that won't accept that signal format.
 
You must log in or register to reply here.
Back
Top