Welcome to our community

Be a part of something great, join today!

Log in
  • Hey all, just changed over the backend after 15 years I figured time to give it a bit of an update, its probably gonna be a bit weird for most of you and i am sure there is a few bugs to work out but it should kinda work the same as before... hopefully :)

Recent content by Alex Finlayson

  1. A

    [FS: GEAR] Arri Cine Plate for DSMC2 (K2.0008886)

    Arri Cine Plate for DSMC2 (K2.0008886), located in United Kingdom. This Arri DSMC2 camera baseplate is for use with an Arri BP8 bridge plate. You can quickly switch between handheld and studio mode whilst retaining two handheld rosettes (if motors top mounted or on 15mm bars). You have 15mm rod...
  2. A

    [FS: RED Gear] RED DSMC2 TACTICAL TOP PLATE

    Red DSMC2 Tactical Top Plate with touchscreen RED monitor input socket and RS Run/Stop 3 Pin Fischer port (non-powered). Located in United Kingdom. This top plate offers multiple 3/8" and 1/4" mounting points for your accessories, great for a lightweight clean camera build and also works...
  3. A

    Lens Motors and Arri UMC-3

    Basically I'm a student who is planning on investing in the new WCU - 3 Wireless unit from Arri but that alone is going to cost me £4500 pounds and I was wondering if anyone had any suggestions for a cheap motor that will connect to the Arri UMC- 3. I have been looking at the Arri CLM 1 motor...
See more
Back
Top