[(RED) WTB] DSMC1 regular redvolts for side handle

[Michael Patterson]

I've been trying to find some extra working small redvolts for the side handle for hot swap. I've burned through over a dozen over the years and am down to only 1 working one. I've purchased and was grifted on eBay for about 8 of them that were said to be working but were far from it... I'd like to get 3 of them, but would take 1 or 2 as long as they are fully functional and tested without the fun little flashing outer leds. Thanks.

 

[Tommaso Alvisi]

Hey Michael, I have the best V-Mount plate ever made for DSMC1, the AerialMediaPros one with a genuine IDX V-Mount plate, pm me if interested.
REDVOLTs are a no go in the long run imho because the high draw will shorten their life significantly in a short time span as you found out...
Cheers!

 

[Michael Patterson]

Hey. Thanks. I just set up a new v mount system as the redvolt xls started failing that I used in my quad module. The only use I have for the standard redvolts in the side handle is for a quick hotswap or accidental ac power interruption. I’ve never really ran the camera on side handle power only. Merely there for safety sake.

 

[Eric Santiago]

I have a few RV and three battery chargers.
They still work but between 60% and 80%.
I too couldn't find any solid ones out there.
Make me an offer and pay shipping it's yours.

 

[Yusuf Thakur]

Hi Micheal, I have two brand new unopened with a charger, can send you pictures and purchase details.
Let me know if you are interested.

Email sent

 

[Yusuf Thakur]

[No message]