HDMI problem with 42" plasma

[tony gardiner]

Hi all,
I need some help, we are trying to connect a panasonic 42" plasma via hdmi, the problem is the picture is offset to the left quite a bit and we are missing at least a third of the image.
I have tried to change the hd sdi settings between 59 and 50 hz also the pvw output between menus/dvi and 720p but it is still offset, any suggestions would be greatly appreciated!
cheers
tony

 

[Andrew McCarrick]

Hi all,
I need some help, we are trying to connect a panasonic 42" plasma via hdmi, the problem is the picture is offset to the left quite a bit and we are missing at least a third of the image.
I have tried to change the hd sdi settings between 59 and 50 hz also the pvw output between menus/dvi and 720p but it is still offset, any suggestions would be greatly appreciated!
cheers
tony

Is there any offset control on the monitor itself? Do you have the 1080P model? If so:

ftp://ftp.panasonic.com/pub/Panasonic/Drivers/PBTS/manuals/OM_TH42505865PF11UK_Eng.pdf

Check out page 23

 

[Bryan Stafford]

i have a sharp 22 inch full hd monitor and i get the same problem. on the monitor itself i can go into the menus and offset the image, but it is still cut off.

any wisdom?