Welcome to our community

Be a part of something great, join today!

Log in
  • Hey all, just changed over the backend after 15 years I figured time to give it a bit of an update, its probably gonna be a bit weird for most of you and i am sure there is a few bugs to work out but it should kinda work the same as before... hopefully :)

lcd lower third flicker

Ok, update, I saw this once today with 2.2.1 so I guess it's still lurking around. I believe the camera was in RedCode 36 mode so perhaps that's got something to do with it? I couldn't duplicate it again afterwards.

Cheers,

Paul
 
Build 15 2.2.5

LCD flicker problem: press user key 2 on camera body (2x magnify) and then right key on LCD (frame guide only mode). Then press user key 2 and then right LCD key. LCD lower part will start to flick. More you move camera, more it flickers. (It seems that it is no problem in 2K modes).

Solution: when lower part flickers, press user key 2 (2x magnify) and then press this key again.
 
Saw it tonight on build 2.2.5 after powering up without the monitor attached and then attaching it. I rebooted and it disappeared.

HTH

Paul
 
LCD flicker

LCD flicker

We see it too. Its most probably a byproduct of the multiple simultaneous monitor outputs that we added in Build 15.

You may not see it at all, but if you do, it should show up only at 4K resolution and in about the bottom 5 % of the image.

Its NOT in the recorded footage.

Thanks for your patience, we'll get it nailed in the near future.
 
I've been getting this on two different camera bodies, on much more than just the lower part of the image. Haven't found a pattern yet as to why... suspect it may be a power issue.
 
You must log in or register to reply here.
Back
Top