Welcome to our community

Be a part of something great, join today!

  • Hey all, just changed over the backend after 15 years I figured time to give it a bit of an update, its probably gonna be a bit weird for most of you and i am sure there is a few bugs to work out but it should kinda work the same as before... hopefully :)

Improving boot time, power efficiency, noise level of camera

combatentropy

Banned
Joined
Apr 22, 2007
Messages
139
Reaction score
0
Points
0
Website
www.combatentropy.com
I was wondering if RED might shed some light on its processing circuits.

I am not an electrical engineer, but the following facts got me thinking: An AVCHD camcorder boots in seconds, runs on a few watts, has no fan, and AVCHD-encodes 30 frames of 2K in real time. Meanwhile, a modern computer boots in a minute, runs on about 100 watts or so, has a big fan, yet exports AVCHD much slower. I think that this is because the camcorder's circuits are custom-built for encoding video while a computer uses a general-purpose processor.

The RED One sounds more like a computer. Yes, it does encode in real time, but it boots in a minute, runs on 75 watts, and has one or more fans.

Of course, wavelet compression takes some serious processor power --- but more than AVCHD? AVCHD sounds even more complicated --- it does this to the image, and then that, and finally this other thing. Meanwhile, wavelet compression is more elegant.

So basically my question is, would RED boot faster and use less electricity if it used more custom-built circuits (ASICs)? I may be way off. Can someone fill me in a little?
 
Back
Top