Freaky Scarlet monitoring

[Edward Blythe]

Check out attached still. This has happened a few times - bottom and sides of the frame 'swap' so the bottom is at the top, the right is at the left etc. So that white wall on the left actually extends from the door jamb on the right. And the bottom of the bed is at the top of the frame.

It makes me punch my face.

Unplugging the LCD/EVF fixes it (happens in both). Anybody seen similar gremlins? Going to flash the firmware and pray for rain.

Also had an issue getting the HD-SDI output happening last night (first time I tried to get signal). Crazy monitor path. No want to send to Red. Want to work.

 

[Jon Carr]

Mine does that sometimes getting out of 1:1 magnify. Annoying but does not effect the footage. So it's a little bug we have to deal with until the next build.

 

[Joe Mannion]

Not sure why it happens but I think turning it off and on again would be safer than pulling the cable.

 

[Steven Dean]

I get random glitches - a kind of stepping effect in the LCD image when switching between resolutions. A re-boot will solve it.

 

[Scott Crawley]

Not sure why it happens but I think turning it off and on again would be safer than pulling the cable.

:iagree:

I recall reading about a number of LCDs that got fried by that kind of thing.

 

[Edward Blythe]

Yikes. I shall banish the practice forthwith.

 

[Marc Berger]

Yes experienced the same and sometimes a strong stuttering effect after black shading. Went after rebooting the cam or shutting down and unplug and plug the LCD cable, then powering up again.

 

[Jon Carr]

I just go in and out of 1:1 magnify a couple of times usually to get out of it.

 

[Edward Blythe]

Excemellent. Thanks lads.

 

[Timur Civan]

Mine does this too.

Reboot fixes it. luckily the reboot is quick.

 

[Trevor Meeks]

Update to 2.0.8 firmware

 

[Jon Carr]

Update to 2.0.8 firmware

Happens in both firmwares

 

[axel ebermann]

had that happen on epic too