Another Monitor Question... Flanders on R1

[Christopher Barrett]

My new LM-1770W only works with my R1 if I set the <Monitor> <Preview> to "Video[720p]" versus "Menus[DVI]". I've tried SDI and HDMI connections to the Flanders and results remain the same. Both settings work fine on the DP1 but the Flanders reports "no signal" when I switch to "Menus[DVI]". This means I have to leave the Red 5.6" on camera for menus and status displays if I want to use the Flanders... Drag.

Anyone have experience and/or thoughts on the matter?

Thanks Much!!!

 

[Andrae Palmer]

With an HDMI to DVI cable connected from RED to Flanders Scientific 24" LM-2461W... I'm getting the same results as you. The monitor will not display a signal when I switch the RED to Menu-DVI. I would love to do so for a meet up tomorrow so more people could see the camera menus.

 

[Christopher Barrett]

Hey Andrae, I also get that over SDI... so the connection to the Flanders makes no difference in my case. Same for you?

 

[Andrae Palmer]

Menu-DVI is meant to work with an HDMI cable. In my case I think the Flanders is not accepting the signal. Kind of strange because it works with Video[720p) on the HDMI to DVI cable. Too bad... I need the full menus for a meet up tomorrow.