I am in contact with RED support and will have to send in the cam.
But since i have a shoot starting in 6 days, i will try my luck here.
I upgraded to 3.06 and my touchscreen started to have strange red stripes, etc. See the attached pic.
After a few days of not using the cam, i wanted to force upgrade bak to stable 3.0, but now none of my mags are visible to the cam anymore, i can't access the drive. Says "NONE"
This is heartbreaking, cause i can't even upload a different firmware.
System Restore didn't change anything, also using DC Power made no difference.
Any suggestions from you guys?
Thanks in advance.