Thread: RED rocket card no display signal

Reply to Thread
Results 1 to 3 of 3
  1. #1 RED rocket card no display signal 
    Edward Tang
    Edward Tang is offline
    Junior Member
    Join Date
    Dec 2011
    Location
    Hong Kong
    Posts
    14
    Default 04-12-2012, 10:47 AM
    Hi Everybody,

    I have no display signal on the LCD monitor after I connect the RED rocket display card using the DVI output connect with the breakout cable. I have been already finished the hardware and software installation with the firmware update.

    And I validated the RED Rocket is already installed in the system shown on.

    I just installed both original and RED rocket in the Mac Pro but I connect the original display card for work only.

    How can I connect the LCD display to the RED Rocket card using DVI output connector with the breakout cable for the display signal?

    Thanks & Regards

    Edward T.
    Reply With Quote  
     
  2. #2  
    Justin Marx
    Justin Marx is offline
    Senior Member Justin Marx's Avatar
    Join Date
    Jul 2011
    Location
    Hollywood, FL
    Posts
    1,242
    Default 04-12-2012, 10:56 AM
    You need to make sure the display is set to your display settings in RCX, in RCX Pro it auto detects..
    Or just call RED
    EPIC-M 1261 - officially named "Take 2"
    Reply With Quote  
     
  3. #3  
    Edward Tang
    Edward Tang is offline
    Junior Member
    Join Date
    Dec 2011
    Location
    Hong Kong
    Posts
    14
    Default 04-13-2012, 02:34 AM
    Thank so much!
    Reply With Quote  
     
Reply to Thread
« Previous Thread | Next Thread »
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules