Histogram not tightly enclosed by raw-bars as in manual

[Martin Beek]

EDIT: problem re-appeared again, read rest of thread.

Question: in the scarlet manual, the histogram is tightly enclosed by the two raw bars.
My histogram does not touch the right, by far. Same on RedMote. I've seen this on screenshots of other people.
Firmware 3.0. But also appeared this way in 2.8 - can't remember about 2.5.



Martin

[Ian B. Johnson]

So do you think it was a matter of the histogram reading incorrectly or your exposure actually being limited by a bad install? And can you post a photo of what the new histogram looks like for comparison?

[Arnold F.]

Here in the states, a raw bar is a place that serves fresh oysters and the like. Many people would enjoy such close proximity to two.

My histogram bumps up to the left bar but there is a gap on the right side.

[Stuart English]

SOLVED!!
--------
Re-installed 3.0, did the calibration and... i have a new scarlet! Histogram now exposes fully to the right and i have gained some RGB headroom too...
--------

Question: in the scarlet manual, the histogram is tightly enclosed by the two raw bars.
My histogram does not touch the right, by far. Same on RedMote. I've seen this on screenshots of other people.
Firmware 3.0. But also appeared this way in 2.8 - can't remember about 2.5.



Martin

Can you re-post that image with False Color overlay enabled ?

if you don't see red on the image can you open the iris until you do ?

if you do then see red, what does the histogram look like ?

[Martin Beek]

I'll post a screendump later tonight or tomorrow, since i don't have the Scarlet at hand at the moment, but now my histogram bumps up to the right raw bar, like in the manual pictures.

I'll get bet to you all soon.


Martin.

[Alvise Tedesco]

Can you re-post that image with False Color overlay enabled ?

if you don't see red on the image can you open the iris until you do ?

if you do then see red, what does the histogram look like ?

I'm not Martin but I have similar problems:
Histogram goes flush to the right bar only @ higher iso. Not so @ 800. Farther still @ 320
Yellow and red doesn't show up in false color @ 320. Yellow show up @ 800 but not red. Both show up from 2500 iso and up
All of this after installing 3.0.0. But histogram was never tightly enclosed by goal posts also on previous firmware.
What to do Stuart?
Thanks

[Patrick Grossien]

Is there any news on the Histogram-Right-Bar front? I'm having the same issue with mine as well. anything we can do?
Tried reinstalling firmware, black shading, restoring factory settings.

[Alvise Tedesco]

Problem not solved for me after reflashing 3.0.0
Submitted a support ticket, but did not received till now the solution other than the suggestion to reflash and re calibrate
Anybody has this same problem?
Help please

[Julio Quintana]

I've been having the same issue where the histogram and even the goal posts don't tell me I'm clipping, so I'm forced to use the Exposure tool.

[Alvise Tedesco]

Thanks.
So do I. But red color on exposure tool shouldn't show up at the exact same time as stoplights? Aren't they applying to raw?
I have a little difference between the 2