bug in a MC 6.0 ama 1.6

[Maicol_Borghetti]

MC 6.0, ama plugin 1.6.
try do this on a red file imported by ama:
right click > Source settings > move exposure, brightness, contrast all the controls are moving just jumping by step of 1.00
so 1.00 or 1.99 not make any difference. just big jump from 1.00 2.00 step.
what can I do'? where I'm wrong?

[MichaelP]

Try entering a value via the keypad to see if you can get to the interim values. Perhaps the left/right arrow keys allow for smaller increments. I need to get in front of a system to see for sure.

Michael

[Maicol_Borghetti]

nothing to do also writing the value... also nothing to do if you create the setting in redcine x and try to load into source settings...
I thinks this one is a BIG bug if confirmed from other user I also was not able to export my mixed media (5d and red one) project. taking error 2034
I came back to 5.5.2 to finish my work than try again. anyway the 6.0 64bit version is super faster compared to 5.5.2 32bit.
Maic

[MichaelP]

Are you saying that creating a interim value in REDCINE X and saving the RMD doesn't appear in source settings when using the RMD?

Michael

[Maicol_Borghetti]

Are you saying that creating a interim value in REDCINE X and saving the RMD doesn't appear in source settings when using the RMD?

Michael

YES, the value remain the default one. I repeat MC 6.0 ama plug 1.6 redcine X build 506.
Actually I have unistalled MC 6.0 and back to 5.5.2 to finishing a work.

[MichaelP]

in MC v6 on Windows 7, i can change values in source settings by .01 increments; 1.10, 1.11, 1.12, etc. Either by sliding the GUI or using the left and right arrows keys after selecting the slider.
If you updated from v5.x.x, the you will want to start with fresh settings as recommended by the RED ME notes.
Michael

[Maicol_Borghetti]

Ok I can change the value number too but this does not affect the video look. the istogram too remain blocked and just jump only when I have a valute of 1 in difference 1 2 3..
can you try again and confirm to me? I will try to reinstall all the sw..

[MichaelP]

Ah - you are saying that you see no difference in the image or the histogram unless it is in 1.0 increments. I'll check.

Michael

[MichaelP]

The histograms change with every +/- .01 increment even though the changes are very subtle. As far as picture, it does change as well, but the changes are as subtle if not more than the histogram but it will change. What is broken is the "apply" which was designed to allow changes to propagate through to the source clip loaded in the source monitor and thus be available as a signal over attached hardware to a calibrated monitor or scope.

Michael

[Maicol_Borghetti]

I try to reinstall all...